Idiomas disponibles
Idiomas disponibles
(Fig.8).
4.3
GRINDING ADJUSTMENT
To adjust the grinding degree, use the adjustment knob (4), turning it clockwise to make
the powder finer or counter-clockwise to increase the grain size as indicated on the
knob (Fig.7). The adjustment is without stops; it must be carried out gradually, grinding
a little coffee every 2 notches at the most.
ATTENTION
If the knob is turned by one full turn with the motor stopped, the machine may
stop.
4.4
SWITCHING ON THE APPLIANCE
Turn the switch (7) to the on position.
When the appliance is switched on for the first time, it will be set to the mode set at the
time it left the factory and, in any case, during subsequent starts, it will always be set to
the last mode before it was switched off.
When switched on, the display shows the operating screen.
4.5
OPERATION
Select the dose to be dispensed using the respective buttons (C), (G) or (E).Rest
the cup of the filter holder on the fork (8), making sure that it is precisely under the
dispensing spout (6). Press the selected dose button again, or the front button (9).
Dispensing ends when the time set in programming has elapsed. Then the grinding
time returns to the set value and the grinder is ready for a new cycle. If continuous
dose is selected (H) the dispensing lasts as long as the button is pressed.
ATTENTION
Automatic dispensing can be stopped before the grinding time has elapsed.
During dispensing, press the selected dose button, or the front activation
button, to stop dispensing:
• Press the button again to resume dispensing for the remaining time;
• Press and hold another dose button for a few seconds to end dispensing. The
grinding time will return to the set value.
5
MACHINE PROGRAMMING
5.1
DOSE ADJUSTMENT
• Select the key (C) or (G) to select the dose to be set.
32
EN
