TEMPUR-PEDIC TEMPUR ERGO Manual Del Propietário página 14

remote control
Remote Pairing
The original remote that comes in the box is already paired to the
adjustable base. No further action is required. In the event that
the remote is not paired with the base, follow the steps below.
STEP 1
Remove rear cover of the remote control by sliding it down
to expose the PAIR button. Unplug the Power Cord from your
power outlet. Wait 1 minute, then plug it back in to your power
outlet. Perform Step 2 within 10 seconds, while the control box
light is flashing.
Power Supply
STEP 2
Press and hold the PAIR button on the
back of the remote. The PAIR button
will illuminate and start to flash. When
the PAIR button stops flashing, the
LED light on the control box will stop
flashing. Release the PAIR button.
STEP 3
Test all remote functions. If the remote buttons do not impact
the adjustable base movements, please repeat the process again
or call customer service: U.S. 1-800-499-1965 |
268-4414
10
Power Cord
Canada 1-800-
Child Lock Feature
WARNING
Children and pets can be crushed or killed in moving parts of
the bed! For safety purposes, the child lock function locks the
remote control to prevent any accidental button presses and
bed movements. Engage child lock on the remote control before
leaving the room.
Activate Child Lock
Press/hold dedicated Child Lock button for
three (3) seconds.
The remote LED will flash twice to confirm
activation. When any button is pressed on
the remote while in child lock mode, the LED
illuminates for 2 seconds or while button is
pressed.
*Child Lock feature will be deactivated when
batteries are removed.
Deactivate Child Lock
Press/hold dedicated Child Lock button and
the Underbed Lighting button together for
three (3) seconds.
The remote LED will flash once to indicate the
remote is no longer in Child Lock. The remote
and adjustable base will work normally.