Idiomas disponibles
Idiomas disponibles
Cod. 94716
Air filter
1. Remove the cover (8) on the front of the generator by removing the two screws.
2. Remove the air filter
3. Wash the air filter in solvent.
4. lubricate the filter using motor oil
5. Thoroughly squeeze the filter removing excess oil
6. Reinstall the air filters.
WARNING:
The use of petrol or combustible solvents for cleaning can cause fire or explosion. Therefore only
use soap water or non-combustible solvent. Never operate the power generator without the air
filter.
SPARK PLUG
RECOMMENTED SPARK PLUG: F6TC
1.To ensure proper engine operation, the spark plug must be properly gapped and free of deposits.
2. Remove the spark plug cap.
3. Clean any dirt from around the spark plug base.
4. Use the wrench to remove the spark plug.
5. Visually inspect the spark plug. Remove carbon deposits using a wire brush.
6. Check for discoloration on the top of the spark plug. The standard color should be a tan color.
7. Check the spark plug gap. The acceptable gap should be between 0.6-0.7mm
8. Install /reinstall the spark plug carefully by hand
9. Once the spark plug has been seated tighten with the spark plug wrench.
10. Reinstall the spark plug cap on top of the spark plug.
Cleaning
1. Keep your machine clean, the outside of the machine can be cleaned using a damp soft cloth
with a mild detergent if required, never use water to clean the generator as it may cause
damage to internal parts.
2. Some maintenance products and solvents may damage the plastic parts, these include
products containing benzene. Trichloroethylene. Chloride and ammonia.
3. Use a vacuum to clean air inlet and outlet louvers of the alternator.
4. Take special care to keep the ventilation inlets /outlets free from obstruction. Cleaning with a
soft brush followed by a compressed air jet will usually be sufficient to ensure acceptable
internal cleanliness.
5. Wear eye protection when carrying out cleaning.
Repairs
2. Only an authorized service centre should repair the generator.
Troubleshooting
Trouble
Possible cause
1. low on fuel/oil content
Suggested remedy
1. add fuel/oil mix
21
