Idiomas disponibles
Idiomas disponibles
TO REPLACE BELT
NOTE: Use replacement belt, see part number detail in REPLACEMENT PARTS (page 7).
1. Install new belt over motor drive, then over belt path.
2. Place agitator assembly back into motorized nozzle.
4. Line up front of cover and base. Rest cover on front edge of base as shown.
Make sure there is no gap between the cover and base.
6. Turn motorized nozzle upside down and replace two (2) cover screws.
Belt Path
Agitator
End Cap
Cover
Side
Rear
Latch
Latches
-34-
Motor
Drive
Base
