Idiomas disponibles
Idiomas disponibles
GB
3.4
Operating information
Please observe the supplied Döllken instructions for hot-melt adhesive to
ensure perfect adhesive application.
• Surfaces to be glued should be be acclimatized to at least 18 °C and free
of dust, grease and moisture. Remainders of wax, separating oils, plasticiz-
ers or impregnation media on the workpieces can lead to loosening of the
adhesion immediately or later.
• Apply the adhesive in a continuous line on the back of the profile.
• The amount of applied adhesive depends on the structure of the wall.
• For wavy, uneven walls, the restoring force of the skirting board must be
compensated for by applying more adhesive.
• It is important to note that the profile should be bonded within 30 seconds
to achieve optimum adhesion.
• Immediately after application, the profiles must be pressed firmly against
the wall, fixed in the installation position and not pulled off.
• Cold wall surfaces (below 16 °C) will reduce the working time!
3.5
Breaks/end of work
Turn the device off at the power switch (6) if you do not require any adhesive
for longer than 20 minutes.
The adhesive can remain in the device and be remelted later on.
3.6
Changing the hook nozzle
To replace a defective hook nozzle, please carry out the following steps.
1. Heat the device up.
2. Separate the device from the mains by removing the mains plug.
3. Unscrew the defective hook nozzle (1) above a suitable surface.
4. Screw in the new hook nozzle with the tip pointing downwards and lock it
with the nut.
5. Check that the hook nozzle on the heated device is firmly seated.
H1079XM_230117.indd 13
Burn hazard!
When carrying out the working steps described below, you must wear
heat-protective gloves!
Note
The hook nozzle has been designed for glueing the rear side of skirting
boards.
Protect from impacts and bending!
13
Operation
24.01.23 10:22
