Idiomas disponibles
Idiomas disponibles
Transportation
•
The product is heavy and can cause crush
injuries. Be careful when you load it onto or off
a vehicle or trailer.
•
Load the product in reverse on approved ramps
of a maximum operation angle of 10°. Do not lift
the product.
•
Use an approved trailer for transportation of the
product.
•
Make sure that you have knowledge of local
road traffic regulations before transportation of
the product in a trailer or on roads.
•
Stop the fuel supply of the product.
•
Lock the product with approved devices, such as
straps. Use tie-down points on the product. The
parking brake is not sufficient to lock the product
during transportation.
To tow the product
WARNING:
product, you must read and understand
the safety chapter. Refer to
safety on page 10 .
•
Be careful when you tow the product.
•
Operate the product slowly when you tow the
product.
•
The breaking distance increases when you tow
the product. Make sure to decreases the speed
in time.
•
For safe operation, do wide turns.
•
Do not tow near ditches, open water, and other
dangerous areas.
Storage
Prepare the product for storage at the end of the
season, and before more than 30 days of storage.
If you keep fuel in the fuel tank for 30 days or
more, tacky particles can cause blockage. This has a
negative effect on the engine function.
To prevent tacky particles during storage, add a
stabilizer. If alkylate gasoline is used, stabilizer is
not necessary. If you use standard gasoline, do
not change to alkylate gasoline. This can cause
sensitive rubber parts to become hard. Add stabilizer
to the fuel in the tank or in the container used for
storage. Always use the mixing ratios given by the
manufacturer. Add the stabilizer and run the engine
for a minimum of 10 minutes.
WARNING:
product with fuel in the tank in an indoor
location or in locations with bad airflow.
Risk of fire if fuel fumes come near
open flames, sparks, or pilot lights in
2062 - 001 - 08.02.2023
Transportation, storage and disposal
Before you tow the
Towing
Do not keep the
for example boilers, hot water tanks and
clothes dryers.
WARNING:
and other flammable materials from the
product to decrease the risk of fire. Let
the product become cool before you put
it in storage.
•
Clean the product. Refer to
on page 18 .
•
Remove unwanted materials from the cooling
fan.
•
Repair paint damages to prevent corrosion.
•
Examine the product for worn or damaged parts
and tighten loose screws and nuts.
•
Remove the battery. Clean it, charge it, and keep
it cool during storage.
•
Replace the engine oil, and discard the waste oil.
•
Empty the fuel tank. Start the engine and run it
until there is no remaining fuel.
Note:
Do not empty the fuel tank if a stabilizer
has been added.
•
Remove the plugs and put about a tablespoon of
engine oil into each cylinder. Manually turn the
engine shaft to apply the oil and put the plugs
back on.
•
Lubricate all grease nipples, joints and axles.
•
Keep the product in a clean and dry area and put
a cover on it for more protection.
Disposal
•
Chemicals can be dangerous and must not be
discarded on the ground. Always discard used
chemicals at a service center or an applicable
disposal location.
•
When the product is worn out, send it to the
dealer or to an applicable recycling location.
•
Oil, oil filters, fuel and the battery can have
negative effects on the environment. Obey
the local recycling requirements and applicable
regulations.
•
Do not discard the battery as domestic waste.
•
Send the battery to a RedMax service agent
or discard it at a disposal location for used
batteries.
Remove grass, leaves
To clean the product
27
