Setup Menu Items; Changing The Variation Count - Keysight Technologies U1241C Guia Del Usuario

Setup Menu Items

Changing the variation count

This setting is used with the multimeter's AutoHold feature (see page 102). When
the variation of the measured value exceeds the value of the variation count, the
AutoHold feature will be ready to trigger. You can enable or disable variation
count from the Setup menu.
The variation count is defined as the set value multiplied by 10, which means
setting 001 to 1999 is equivalent to setting 10 to 19990 counts respectively.
Parameter
AH
To change the variation count:
1 Press and hold
2 Press
Figure 4-1
3 Press
4 Press
Keysight U1241C/U1242C User's Guide
Range
(001.d to 1999.d) or (001.E to 1999.E)
View
Shift
Esc
access the Setup menu.
MaxMin
or
Hz
AH display
Vsense
or
enable variation count, change the last digit shown from d (disabled) to E
(enabled).
Log
to save your changes or
Hold
while turning the rotary switch (from OFF to on) to
Auto
until is shown on the secondary display.
Range
MaxMin
and or
Hz
Multimeter Setup Options
Defaul t setting
005.d (disabled)
Auto
to set the variation count. To
Range
View
to discard your changes.
Shift
Esc
4
119