F U N C T I O N D E S C R I P T I O N; U S E A N D F U N C T I O N - Lenz rcB1200 Manual De Instrucciones

F U N C T I O N D E S C R I P T I O N

lithium pack insole rcB 1200
The battery packs have three operating modes: POWER OFF – STANDBY – IN USE. They are
indicated by the heat setting display on the battery pack. The number of illuminated LEDs
corresponds to the selected heat setting.
POWER-OFF:
 The battery pack is completely turned off and the heat setting display (Fig. 1.2) is permanently off.
 They can only be switched on with the control button (Fig. 1.3) of the battery packs.
Note:
The battery packs cannot be switched manually to POWER OFF mode.
If a sole is not connected to the battery packs and the battery packs are in
STANDBY mode, the battery packs will automatically switch to POWER OFF mode
after 12 hours!
STANDBY:
 The heat setting display (Fig. 1.2) briefly flashes at an interval of 2.5 seconds.
 The battery packs are in stand-by and can be activated with the control button of the battery packs
(Fig. 1.3), via the Lenz HeatApp (Smartphone) or via the remote control (available as an
accessory).
IN USE:
 The battery pack supplies the connected Lenz insole with energy and the LED of the heat setting
display or the operating mode display (Fig. 1.2) is illuminated.

U S E A N D F U N C T I O N

Turning on/off:
Briefly (approx. 1 sec.) press the control button (Fig. 1.3) to turn on the battery packs at the lowest
heat level.
– 93 –