Idiomas disponibles
Idiomas disponibles
Submerge the vibratory poker into the concrete in all areas of the formwork. Compact the concrete
with particular intensity at the formwork corners, because these are the areas with the highest density of
reinforcement.
Avoid bringing the vibratory poker into contact with the reinforcement. The adherence of the concrete to the
reinforcement can be lost and the vibratory poker can be damaged.
6.3
Performing compacting work
For optimum results, always keep the submerged vibratory poker vertical and avoid sideways movements.
Do not switch the product on until the vibratory poker is fully submerged in the fresh concrete.
1. Hold the product securely with one hand on the housing (see → page 19), while inserting the vibratory
poker into the fresh concrete.
2. Set the switch-on interlock to
3. Allow the vibratory poker to remain in the fresh concrete for several seconds.
4. Switch the product off and set the switch-on interlock to
5. Lift the product straight up to withdraw the vibratory poker from the fresh concrete.
6. Repeat the procedure at all deployment locations.
7
Care and maintenance
WARNING
Risk of injury with battery inserted !
▶ Always remove the battery before carrying out care and maintenance tasks!
Care of the product
•
Carefully remove stubborn dirt.
•
Carefully clean the air vents, if present, with a dry, soft brush.
•
Use only a slightly damp cloth to clean the housing. Do not use cleaning agents containing silicone as
these can attack the plastic parts.
•
Use a dry, clean cloth to clean the contacts of the product.
Care of the Liion batteries
•
Never use a battery with clogged air vents. Clean the air vents carefully using a dry, soft brush.
•
Avoid unnecessary exposure of the battery to dust and dirt. Never expose the battery to high levels of
moisture (e.g. by being dipped in water or left in the rain).
If a battery has been soaked by moisture, treat it as a damaged battery. Isolate it in a non-flammable
container and consult Hilti Service.
•
Keep the battery free of extraneous oil and grease. Do not permit dust or dirt to accumulate unnecessarily
on the battery. Clean the battery with a dry, soft brush or a clean, dry cloth. Do not use cleaning agents
containing silicone as these can attack the plastic parts.
Do not touch the contacts of the battery and do not remove the factory-applied grease from the contacts.
•
Use only a slightly damp cloth to clean the housing. Do not use cleaning agents containing silicone as
these can attack the plastic parts.
Maintenance
•
Check all visible parts and controls for signs of damage at regular intervals and make sure that they all
function correctly.
•
Do not use the product if signs of damage are found or if parts malfunction. Immediately have the product
repaired by Hilti Service.
•
After cleaning and maintenance, install all guards and protective devices and check that they are in full
working order.
To help ensure safe and reliable operation, use only genuine Hilti spare parts and consumables. Spare
parts, consumables and accessories approved by Hilti for use with your product can be found at your
Hilti Store or online at: www.hilti.group
7.1
Instructions for care of compactors
•
After each use, clean the vibratory poker and the protective hose in running water (e.g. with a water
hose).
22
English
and press the control switch. → page 21
.
2361797
*2361797*
