Idiomas disponibles
Idiomas disponibles
SHARPENING THE SAW CHAIN
Keep chain sharp. Your saw will cut more efficient and more
safely. A dull chain will cause undue sprocket, guide bar,
chain, and motor wear.
Do not force chain into wood to prevent the saw chain from
becoming dull.
NOTE:
Do not sharpen the saw chain by yourself unless you are
experienced in doing so. It is recommended to have the
chain saw sharpened by an authorized service.
WARNING:
Switch off and remove the battery pack before
servicing. Cutting edges on chain are sharp.
Use protective gloves when handling chain.
To sharpen the chain:
1. Using protective gloves, ensure the chain is correctly
tensioned on the guide bar.
2. Use a round file with a diameter 1.1 times the cutting
tooth depth. Make sure 20% of the file diameter is
above the cutter's top plate (Fig.19).
3. File at an angle perpendicular to the bar, and at an
angle of 25˚ to the direction of travel (Fig.20).
4. File each tooth from the inside towards outside only. File
one side of the chain first then turn the saw around and
repeat the process.
• Sharpen each tooth equally by using the same number
of strokes.
• Keep all cutter lengths equal. Each time the cutting tip is
sharpened the cutting length is reduced. When the cutter
length is reduced to 0.16 inch (4 mm), the chain is worn
out and should be replaced.
• The depth gauge setting is also reduced with each
sharpening. Every 5 sharpenings use a depth gauge
measuring tool to check the height between the cutting
tip and the ridge. When necessary, use a flat file to file
down the ridge to achieve the 0.25 inch depth gauge
setting. Depth gauge measuring tools are available from
most pole saws retailers (Fig.21).
• If the saw is not functioning properly, take it to a qualified
pole saw service center to have the saw inspected. Use
only identical parts as listed in this manual.
CLEANING
• Remove debris from the saw chain and guide bar.
• Always clean out wood chips, saw dust and dirt from the
guide bar's groove when replacing the chain.
• Ensure that the chain tensioning gear is free of wood
chips and other debris.
• Use a small brush to clean the outside of the unit.
WWW.SENIXTOOLS.COM
• Wipe power head with a clean cloth moistened with a
mild soap solution. Never use harsh cleaners or solvents.
• Remove wood chips and other debris from air vents.
• Clean dirty contacts with a soft, dry cloth. Dirt or oil can
cause a poor electrical connection, resulting in loss of
power.
TRANSPORT
• Remove the battery pack from the pole saw.
• Clean the product as described above.
• Install a guide bar cover.
• Always carry the product by its handle.
• Protect the product from any heavy impact or strong
vibrations which may occur during transportation in
vehicles.
• Secure the product to prevent it from slipping or falling
over, damage or injury.
STORAGE
• Remove the battery pack from the pole saw.
• Clean the product as described above.
• Store the product and its accessories in a dark, dry, frost-
free, well-ventilated place.
• Always store the product in a place that is inaccessible
to children.
• We recommend using the original package for storage or
covering the product with a suitable cloth or enclosure to
protect it against dust.
NOTE:
To prolong battery life, never store battery pack in a
completely discharged condition. Make sure the battery
pack is charged once per year or when the LED indicator
shows only one light.
DISPOSAL
Waste product should not be disposed of with household
waste. Please recycle where facilities exist.
Check with your local authority or retailer for recycling
advice.
During the operation, the limbs or branches may be cut
by the unit, users should clean these objects to protect
environment.
Electrical products should not be discarded with
household products. Used electrical products
must be collected separately and disposed of at
collection points provided for this purpose. Talk
with your local authorities or dealer for advice
on recycling.
21 - EN
