Wesco WS8511 Manual Del Usuario página 13

Soplador inalámbrico de iones de litio
Idiomas disponibles

Idiomas disponibles

SYMBOLS
Warning
Read the operator's manual
Wear eye protection
Do not use in the rain or leave outdoors
while it is raining.
Keep bystanders away
Li-Ion battery. This product has been
marked with a symbol relating to 'separate
collection' for all battery packs and
battery pack. It will then be recycled or
dismantled in order to reduce the impact
on the environment. Battery packs can
be hazardous for the environment and for
human health since they contain hazardous
substances.
Do not burn
Batteries may enter water cycle if disposed
improperly, which can be hazardous
for ecosystem. Do not dispose of waste
batteries as unsorted municipal waste.
For indoor use only
T 2A
Fuse
Positive terminal
Negative terminal
Double insulation
EN
OPERATING
INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
Intended use
The blower is intended for blow debris. It's not intended
for use indoors and animal grooming.
BEFORE OPERATION
1. CHARGING THE BATTERY PACK
a)
Do not use any charger other than that specifically
provided for use with the equipment.
b)
If the battery pack is very hot you must remove your
battery pack from the charger and allow time for the
battery to cool down before recharging.
c)
The battery in your new tool is not charged when it
leaves the plant. Therefore it must be full charged
before using the first time.
d)
Please charge the battery to reach full or no less than
half charge before storage. If the tool will not be used
for long periods of time, charge the battery every 3-6
months.
CHARGING PROCEDURE (SEE FIG. A)
1)
Plug the charger into an appropriate outlet. The light
will be green.
2)
Slide the battery pack into the charger, the light will turn
to red to indicate the charging process has started.
3)
When charging is completed, the light will turn to
green. The pack is now fully charged, unplug the
charger and remove the battery pack.
CHARGING INDICATOR
This charger is designed to detect some problems that
can arise with battery packs. Indicator lights indicate
problems (see table below). If this occurs, insert a new
battery pack to determine if the charger is OK. If the
new battery charges correctly, then the original pack is
defective and should be returned to a service center or
recycling service center. If the new battery pack displays
the same problem as the original Battery Pack, have the
charger tested at an authorized service center.
Light
Red on
Green on
WARNING: When battery charge runs
out after continuously use or
exposure to direct sunlight or heat, allow
Status
Charging
Fully Charged
13
loading

Este manual también es adecuado para:

Ws8511.9Cbv18lw