Idiomas disponibles
Idiomas disponibles
RZ_FineCut18V.qxp_Text_GB 06.02.23 19:42 Seite 31
Figures 14 - 15
14
15
-
Press both angle adjustment but-
tons (I) simultaneously to adjust
the tube. The angle (I) can be
adjusted in 9 stages. You can
therefore work under obstacles
when it is set flat.
8.2.2 Battery status indicator
The device is equipped with a battery
charge indicator (C) that displays the
charging status of the battery. The dis-
plays only light up when the device is
switched on.
Battery capacity (green LEDs):
Reserve
≤ 30%
Temperature protection:
Low voltage cutoff
NOTE!
In rare cases, after the battery has been
removed and then reinserted, the battery sta-
tus indicator (green LEDs) can display a high-
er battery power than before battery
removal. The reason is that the last battery
power during operation is saved in the
device. Once the battery has been removed
and reinserted into the device, the battery
power is re-measured and a higher power
can therefore be displayed on the indicator.
8.2.3 Battery runtime
The battery operating time essentially
depends on the load on the device and
can lead to shorter battery operating
times. Another factor is overly frequent
starting and stopping during cutting,
which can also reduce battery operating
time.
9
Maintenance & Cleaning
Figures 16 - 26
≤ 60%
100%
31
WARNING
RISK OF INJURY DUE TO UNIN-
TENTIONAL SWITCHING ON AND
SHARP/POINTED BLADES!
Some parts of the grass trimmer have
sharp edges and could cause injury.
Switch off the device and remove the
battery.
Wear protective gloves during main-
tenance and cleaning!
Slide the blade guard (K) onto the
blades (J).
CAUTION
RISK OF BURNS CAUSED BY HOT PARTS!
During assembly or conversion work the
drive parts of the device or components
can still be very hot and may cause
burns. It is therefore important to
observe the following safety instruction:
Wear protective gloves during main-
tenance and cleaning!
9.1 Replacing the blades
WARNING
RISK OF CUTTING INJURY FROM
SHARP
/
POINTED
BLADES!
Only assemble with the blade guard
attached (K)!
NOTE!
Tools required:
Phillips screwdriver
16
Loosen and remove the 7 marked base
cover screws on the underside of the device.
17
Lift the base cover from the device and
remove it.
18
To remove the blade set, loosen and
remove the remaining screw indicated.
19
Lift the blade set from the device and
remove it.
20
If necessary, use a brush to clear away any
dirt from the housing and the two seals.
21
Before fitting the new blade set, make sure
that the marks on the two large cog wheels
line up with the marks on the housing. The
two cams must be positioned as shown.
METAL
