SWAP OUTLET SIDE (OPTIONAL)
3. Position the outlet on the left-hand side and re-install with the two #6-32 x 1/4" screws
[203-1115] removed previously.
Reconnect the JST connectors (white) between the power supply and the circuit board.
Position the power supply on the right-hand side, and install with the two #6-32 x 1/4"
screws [203-1115] removed previously. Be careful not to pinch or cut any wires.
Reconnect the Black (L) and White (N) thick power wires from the outlet and power supply
to the Wago connectors by lifting the three orange tabs of the 3-tab WAGO connector.
Insert the Black (L) wire from the power supply in one of the square holes in the WAGO
connector; insert the Black wire from the outlet in the second square hole in the WAGO
connector. Lower the three tabs on the 3 tab WAGO connector. Repeat this process
for the White (N) wires from the power supply and outlet on the second 3-tab WAGO
connector. When you are finished, the Black (L) wires should be in one WAGO connector;
the White (N) wires should be in another.
NOTE: Ground (GREEN) Screw must remain on top of outlet as shown in Figure 3.
©2020 Robern, Inc. 701 N. Wilson Ave. Bristol, PA 19007 U.S.A.
Part no. CB-209-1346 09/23/20
800.877.2376
www.robern.com
Portray Electric Upgrade
6
