FUXTEC FX-MS125 Manual De Instrucciones página 56

Original Bedienungsanleitung FUXTEC FX-MS125_de_en_fr_ita_es_rev01
5. Starter handle: set the on/off switch to 1
6. Hold the device and carefully pull out the starter rope until you feel the first
resistance. This is the starting position for the pull starter. Now pull the rope several
times until the engine starts and runs.
Avoid pulling the rope to the end or letting it recoil by releasing the handle. Such actions
may cause the starter to fail.
IMPORTANT: The device is equipped with a centrifugal clutch so that the
cutting tool starts moving as soon as the engine is put into the start position by
operating the throttle. When starting the engine, place the product on the
ground in a level, clear area and hold it firmly so that neither the cutting part
nor the throttle lever can come into contact with any obstacle when starting
the engine.
7. Allow the engine to warm up for a few minutes at idle after starting before starting
work!
NOTE: If the machine does not start after repeated attempts, please read the
troubleshooting chapter.
NOTE: Always pull the starter rope straight out. Pulling the starter at an angle will cause
the rope to rub against the eyelet. The diagonal pull can cause the starter rope to fray or
break. Always hold the starter handle when the rope retracts. Never allow the rope to be
thrown back from the pulled-out position. This could damage the starter device.
56