Probuilder 16620 Manual De Instrucciones página 54

STEP 1
Screw M5*10
Lay the two back panels flat and
connect them with M5*10 screws and
nuts. Note that the upper and lower
end holes are in the same position.
STEP 3
Install the right side panel according
to the second step. Pay attention to the
position of the upper and lower end
holes, the two side plates are symmet-
rical.
Nut M5
QTY:6 PCS QTY:6 PCS
Screw M5*10
QTY:6 PCS
54
STEP 2
Place the left panel as shown, and con-
nect it with the back panel with M5*10
screws. Pay attention to the position of
the upper and lower end holes.
STEP 4
Top Panel
To install the top and bottom panels,
the side panels should be inserted be-
tween the triangular lines on the inner
side of the top and bottom panels and
the sides. One end of the four round
holes of the side plate is the upper end.
Screw M5*10
QTY:6 PCS
Bottom
Panel