Idiomas disponibles
Idiomas disponibles
4.2. Preparation for cutting
1. Connect the power cable to the power supply (check the voltage according to the parameters in
section 2).
2. Connect the air hose to the air inlet connection in the machine and the ground clamp to the
workpiece.
3. Turn on the equipment and verify that the power supply LED is on.
4. Press and hold button 1 for 10 seconds to check the air inlet pressure and adjust until the alarm
disappears.
5. After verifying that the air is dry, free of oil, without obstructions and within the pressure limits, the
equipment will be ready to be used.
6. Start using the equipment.
RECOMENDED
0.50 m/min.
12MM
5. MAINTENANCE & TROUBLESHOOTING
5.1. Basic troubleshooting guide.
The voltage and amperage inside the machine can injure or even kill, do not try to repair it. Only
properly trained and certi ed personnel should open and repair the equipment.
MAXIMUM
0.25 m/min.
16MM 20MM
Warning: Check consumables constantly and if they are damaged,
replace them. Disconnect the power cord of the equipment before
checking or removing consumables from the torch.
07
SWEISSWELD.COM
SEVERANCE
CAPACITY
0.12m/min.
CUTTING SPEED
THICKNESS
