Chain Tension - Kamikaze KVS8000 Manual Del Usuario

•
Assemble again the bar, the chain and the cover as specified in paragraph 14.3
14.1 Maintenance
General maintenance, cleaning, lubrication and the replacement of the chain and / or bar require
disassembly and assembly of the chainsaw.
14.2 Chain and bar disassembly
•
Disconnect the battery from the chainsaw.
•
Using the wrench supplied, unscrew the nuts (1) and remove the casing (2).
•
Unscrew the chain tension adjusting screw (3) to loosen the tension.
•
Remove the chain and bar.
1
14.3 Chain and bar assembly
•
Disconnect the battery from the chainsaw.
•
Remove the cover (2) by removing the adjusting screws (1).
•
Move the chain tension adjusting screw (3) to be able to place the bar in the housing of chainsaw
body (4).
•
The front and back face of the bar are the same, you can mount it interchangeably. Insert the chain
into the bar groove (5), make sure that the chain cutting direction is correct and insert the male
fixing of the tension screw (6) into the fixing hole (7) of the bar.
•
Insert the chain on transmission pinion (8).
•
Mount the cover (9) and tighten the two back fixing nuts (1).
5

14.4 Chain tension

While using the chainsaw, the chain overheats and could stretch. If necessary, adjust the chain tension
as indicated below:
7
8
6
2
3
4
9
43