VONROC MS506AC Traducción Del Manual Original página 12

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 55
EN
Replacing the saw blade (Fig. D, E, F)
Before carrying out any work on the
machine, disconnect the mains plug from
the power supply.
When mounting the saw blade, wear
protective gloves. Danger of injury when
touching the saw blade.
Only use saw blades that correspond with
the characteristic data given in the operating
instructions. Use only saw blades that are
marked with a speed equal or higher than
the speed marked on the machine.
Do not under any circumstances use
grinding discs as the cutting tool.
Before replacing the saw blade, it is strongly advised
to set the mitre angle and bevel angle to 0°. Other-
wise, access could be limited.
• Disconnect the machine from the power supply.
• Remove the screw (33) that holds the retraction
arm to the blade cover.
• Remove the screw (40) in order to remove the
bolt-cover by lifting the blade cover (5) upwards.
• Both saw blade bolt (42) and Flange (41)
should be visible now like shown in fig. E.
• Press the saw blade lock button (43) Rotate
the saw blade carefully by hand until the blade
locks.
• Use hex key to remove the saw blade bolt (42)
by loosening in a clockwise direction.
• Remove the Flange (41) and the saw blade
• Replace the saw blade making sure that the
arrow marked on the saw blade must point in
the same direction as the arrow shown marked
on the machine. The saw blade teeth must point
downwards.
• Fix the saw blade bolt (42) use the saw blade
lock button (43) in order to secure tightly.
• Lower the blade cover (5) in order for the bolt
cover to fall back into place and tighten the
screw (40).
• Attach the retraction arm back onto the blade
cover (5) by tightening the screw (33).
• Rotate the saw blade and check if the guard
operates freely.
12
Dust extraction (Fig. A, B, T)
Provide good ventilation at the workplace.
Wear dust protection.
The dust from materials such as lead paint and
some types of wood can be harmful to your health.
Breathing in this dust can cause allergic reactions
and/or cause respiratory illnesses for the user or
people in the near vicinity. Certain dusts, such as
oak or beech dust, are classified as carcinogenic,
especially in conjunction with wood treatment ad-
ditives (chromate, wood preservative). We strongly
advise to use a dust extraction system that is suita-
ble for the material wherever possible.
Avoid dust accumulation at the workplace.
Dust can easily ignite.
The dust extraction system can be blocked by dust,
chips or fragments of the workpiece. Thus, it must
be cleaned regularly. To do so:
1. Disconnect the mains plug from the power
supply.
2. Wait until the saw blade has come to a complete
stop.
3. Remove any blockage if necessary
Mounting the dust bag (Fig. A, B)
Press in the clamp of the dust bag (26) and slide it
onto the dust outlet (28) on the back of the machine.
The dust bag stays in place when releasing the clamp.
Connecting a vacuum cleaner (Fig. A, B, T)
The dust extractor must be suitable for the
material being worked.
When vacuuming dry dust that is especially
detrimental to health or carcinogenic, use a
special dust extractor.
A vacuum cleaner hose can be connected to the
dust outlet (28). To do so, simply connect the vacu-
um hose to the dust extraction spout.
4. OPERATION
Before you turn on the machine, always
check that the saw blade is fitted correctly.
The blade must turn smoothly.
WWW.VONROC.COM
loading