Speed Adjusting Dial; Hex Wrench Storage - Makita SP6000 Manual De Instrucciones

CAUTION:
Before plugging in the tool, always check to see
•
that the switch trigger actuates properly and
returns to the "OFF" position when released.
To prevent the switch trigger from being accidentally
pulled, a lock-off button is provided. To start the tool,
push in the lock-off button and pull the switch trigger.
Release the switch trigger to stop.

Speed adjusting dial

007663
The tool speed can be adjusted by turning the adjusting
dial. Higher speed is obtained when the dial is turned in
the direction of number 6; lower speed is obtained when
it is turned in the direction of number 1.
Refer to the table to select the proper speed for the
workpiece to be cut. However, the appropriate speed
may differ with the type or thickness of the workpiece. In
general, higher speeds will allow you to cut workpieces
faster but the service life of the blade will be reduced.
Number
1
2
3
4
5
6
015570
CAUTION:
The speed adjusting dial can be turned only as far
•
as 6 and back to 1. Do not force it past 6 or 1, or
the speed adjusting function may no longer work.
The speed adjusting dial is not for using low speed
•
rated saw blades but for obtaining a speed which is
suitable to material of workpiece. Use only saw
blades which are rated for at least the maximum no
load speed stated in the SPECIFICATIONS.
The tools equipped with electronic function are easy to
operate because of the following features.
Overload protector
When the tool is overloaded and current flows above a
certain level, the tool automatically stops to protect
motor.
1. Speed adjusting
dial
1
/min (RPM)
2,000
2,500
3,500
4,500
5,500
6,400
Constant speed control
Electronic speed control for obtaining constant speed.
Possible to get fine finish, because the rotating speed is
kept constant even under load condition.
Soft start feature
Soft start because of suppressed starting shock.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the
tool.

Hex wrench storage

007684
Hex wrench is stored on the tool. To remove hex wrench,
just pull it out.
To install hex wrench, place it on the grip and insert it as
far as it will go.
Removing or installing saw blade
CAUTION:
Do not use saw blades which do not comply with
•
the characteristics specified in these instructions.
Use only saw blades which are rated for at least
•
the maximum no load speed stated in the
SPECIFICATIONS.
Be sure the blade is installed with teeth pointing up
•
at the front of the tool.
Use only the Makita wrench to install or remove the
•
blade.
To remove the blade, push in the lock-off button to
unlock the upper limit stopper.
2
1
007662
Turn the locking lever to lock the saw head for replacing
a blade.
8
1. Hex wrench
1
1. Lock-off button
2. Locking lever