Bosch GCU18V-30 Instrucciones De Funcionamiento Y Seguridad página 10

Disconnect battery pack from tool before making any assembly, adjustments
or changing accessories. Such preventive safety measures reduce the risk of
starting the tool accidentally. Make certain that the collet nut is securely tightened before turning
the tool on.
The rated speed of the accessory must be at least equal to the maximum speed
marked on the power tool. Accessories running faster than their rated speed can
break and fly apart.
Wear protective gloves when installing and replacing bits. Bits intended for
cutout tools have sharp surfaces.
Removing, Installing, and
Adjusting the Adjustable Depth Stop
and Dust Hood Assembly
In order to remove the adjustable depth stop
(Figure 2, 2) and dust hood (3) assembly from
the tool, turn the adjustable depth stop knob (9)
counter-clockwise until you can remove it from
the tool. The adjustable depth stop (2) and dust
hood (3) assembly should then pull freely from
the tool. Be careful not to lose the washer that
is on the adjustable depth stop knob (9) screw.
To reattach the adjustable depth stop (2) and
dust hood (3) assembly, line up the slot in the
adjustable depth stop (2) and dust hood (3)
assembly with the threaded hole in the metal
housing and re-install the adjustable depth stop
knob (9) by rotating it clockwise until tight. Be
careful not to cross-thread the adjustable depth
stop knob screw.
The adjustable depth stop (2) allows you to
control the depth of cut. Loosen the adjustable
depth stop knob by turning it counter-clockwise
until the depth stop can slide freely. For bits with
a guide point, make sure that the entire guide
point tip will extend 1/8" (3.18 mm) beyond the
material thickness (Fig. 2). For standard point
drywall bits, make sure that the fluted end of the
bit extends 1/8" (3.18 mm) beyond the material
thickness.
2610067307_GCU18V30_202203.indd 10
page heading Assembly
Fig. 2
-10-
(3)
(2)
(9)
3/30/22 8:33 AM