EGO PS1000E Manual De Instrucciones página 14

TROUBLESHOOTING
EN
PROBLEM CAUSE
◾
The battery pack is not attached to the
pole saw.
◾
No electrical contact between the saw
and battery.
◾
The battery pack is depleted.
◾
The lock-off button is not depressed
before pressing the trigger switch.
◾
The battery pack or power head is
too hot.
MOTOR DOES
◾
Saw chain is bound in the wood.
NOT RUN.
◾
The bar and chain are skew and are
not parallel to the housing.
◾
Debris in bar groove.
◾
14
56 VOLT LITHIUM-ION CORDLESS POLE SAW— PS1000E
Debris in side cover.
SOLUTION
◾
Attach the battery pack to the pole saw.
◾
Remove battery, check contacts and reinstall the
battery pack.
◾
Charge the battery pack.
◾
Press down the lock-off lever and hold it, then
depress the trigger switch to turn on the pole
saw.
◾
Allow the battery pack or power head to cool
until the temperature drops to the recommended
operating temperature range.
◾
Release the trigger switch; remove the saw
chain and guide bar from the wood, then restart
the pole saw.
◾
Remove the battery pack and replace the bar
and chain following the section "REPLACING
THE BAR AND CHAIN". Always remember to
keep the bar and chain parallel to the mounting
surface before installing the side cover.
◾
Press the saw chain against the wood, move the
pole saw back and forth to discharge the debris.
◾
Remove battery pack, then remove side cover
and clean out debris.