Idiomas disponibles
Idiomas disponibles
Original User Manual FUXTEC FX-RM Series_de_en_fr_ita_es_rev23
24.
Starting / stopping the engine
Start (except FX-RM5196eS, FX-RM5196eSPRO, FX-RM5396PeSPROsee previous pages)
Make sure that the engine is filled with sufficient oil and gasoline before you start it.
Pull the brake lever (upper lever) against the handle and pull the starter cable slightly until resistance is
felt. Then pull the starter cable smoothly until the engine starts. On the 4646eco model, please press the
primer pump 3-5 times before pulling the starter cable to fill the carburetor with gasoline.
NOTE:
Do not operate the wheel drive lever at the same time. Only when the engine has started, and you want
to use the self-propulsion do you operate the lower lever.
Due to a protective layer on the engine, a slight smoke may be produced when you use the device for the
first time. This is a standard procedure. Pull the brake lever towards the push handle. Do not let the pull
starter snapback.
Stop
Release the brake lever to stop the motor.
WARNING:
The blade will continue to rotate for a few seconds after the engine is turned off. Unplug
the spark plug connector when leaving the mower unattended.
MOWING INSTRUCTIONS
- In certain circumstances, such as high grass, it may be necessary to raise the cutting height to reduce
the thrust and engine load, which can also lead to grass residue. It may also be required to reduce the
basic speed and push the mower twice over this area
- Reduce the cutting width by covering the previous cut again to perform heavy cutting work
- The pores in the grass catcher bag can become clogged with dirt and dust, which means that the catcher
can pick up fewer cuttings. To avoid this, you should regularly wash the catcher with a water hose and let
it dry completely before reusing it.
- Keep the upper part of the engine around the starter free of grass and chopped grass clippings. This will
improve engine airflow and prolong engine life.
1
62
