Idiomas disponibles
Idiomas disponibles
Changing the tool.
Before mounting or replacing application tools or accessories, remove the
WARNING
battery. This preventive safety measure rules out the danger of injuries
through accidental starting of the power tool.
For all work or when changing application tools, always wear protective
CAUTION
gloves. Danger of injury from the sharp edges of the application tools. Appli-
cation tools can become very hot while working. Danger of burns!
The application tool can be offset in 30°
steps and fastened in the most favorable
working position.
When changing application
CAUTION
tools with sharp cutting
edges, use cover to protect yourself against
hand injuries.
Before using, sharpen used and even new
cutter blades with a sharpening stone.
Mounting or replacing a sanding
sheet (figure 5).
The sanding pad (round or triangle-
poligon) or the carbide rasp can be fas-
tened on the drive shaft at the suitable posi-
tion. An adapter is required for working
with the sanding pad.
Align the sanding sheet and press it manually
against the sanding pad.
Firmly press the power tool with the sand-
ing sheet against a flat surface and briefly
switch the power tool on. This provides for
good adhesion and prevents premature
wear.
When only one tip or corner of the sanding
sheet is worn, it can be removed again and
reattached turned by 120°.
The symptom for worn blades is a clearly
increased feed force at lower working prog-
ress.
Firmly press in the fastening
CAUTION
element to the stop. Then
lock the clamping lever.
Protect your hand and fin-
CAUTION
gers against bruising when
locking the clamping lever. The clamping
lever snaps back vigorously by means of
spring force.
Fig. 5
Sanding sheet
Fastening element
Sanding pad
Adapter
Tool holder
Clamping lever
en
180°
17
