JETT 16 Guía De Montaje página 9

3.6
Fig. 3.6
While holding the rear packaging tower, roll the bicycle forward out of the base packaging.
„
Flip the kickstand down to hold the bicycle upright for assembly.
„
Do not remove Jett 16 models from the rear tower and base packaging until
the rest of the assembly steps are completed. The Jett 16 does not come with a
kickstand. The packaging will hold the bicycle upright during assembly.
RECYCLE: Please recycle all of the packaging.
7
U S I N G T H E T O R Q U E W R E N C H & F L A T W R E N C H
Your Jett bicycle is supplied with a custom torque wrench and flat wrench which should be
used to tighten the bolts where indicated. It is important to properly use a torque wrench
during assembly to make sure all bolts are tightened to specification. Keep both wrenches for
future adjustments and maintenance.
WARNING! Correct tightening force on fasteners (nuts, bolts, screws) on your
bicycle is important for your safety. If too little force is applied, the fastener may
not hold securely. If too much force is applied, the fastener can strip threads,
stretch, deform, or break.
An incorrect tightening force can result in component failure, which can cause
you to lose control and fall. Where indicated, ensure each bolt is torqued to
specification. After your first ride, and consistently thereafter, recheck the
tightness of each bolt to ensure secure attachment of the components.
Following are instructions on how to use the provided torque wrench and flat
wrench. If after reading the instructions you are still unsure of how to use the
torque wrench or flat wrench, please contact your Authorized Specialized
Retailer for assistance.