Unpacking Instruction; Power Supply; Replacing The Fuse; Front Panel - Power Dynamics PDW Serie Manual De Instrucciones

UNPACKING INSTRUCTION

CAUTION! Carefully unpack the box upon receipt. Check the contents to ensure that all parts are present and have been
received in good condition. Notify the shipper immediately and retain packaging material if any parts appear damaged from
shipping or the package itself shows signs of mishandling. Save the package and all packaging materials. If the product must be
returned, it is important that the product is returned in the original factory box and packaging.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The
arising condensation water might damage your device. Leave the device switched off until it has reached room temperature.
POWERSUPPLY
On the label on the backside of the product is indicated on this type of power supply must be connected. Check that the mains
voltage corresponds to this, all other voltages than specified, the light effect can be irreparably damaged. The product must also
be directly connected to the mains and may be used. No dimmer or adjustable power supply.
Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriate
electrical ground to avoid the risk of electrocution or fire.

REPLACING THE FUSE

If the fuse is defective, replace the fuse with a fuse of the same type and value. Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Open the fuse holder on the rear panel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuse holder.
Step 3: Install the new fuse in the fuse holder.
Step 4: Replace the fuse holder in the housing.

FRONT PANEL

1. DISPLAY: The display shows multiple forms of information, for example current MODE, elapsed time, etc.
2. BUTTON CLUSTER:
Mode - Press to change modes between playing SD, USB, MP3, FM and BT.
Previous - Press this button to go to the previous track/station. Press and hold to lower the volume level.
Next - Press this button to go to the next track/station. Press and hold to increase the volume level.
Repeat - Press the repeat button once to continually repeat ALL tracks, press repeat once more to repeat just the current
track.
Play/pause / Store FM- Press this button to start/resume or pause play. Press and hold to automatically scan for FM
stations and store them in FM mode.
3. USB PORT: You can play media files from a USB device by connecting the device to this slot.
4. SD CARD SLOT: Insert an SD card in this slot.
5. MIC1 OUTPUT LEVEL CONTROL: Adjust the volume of the MIC1 channel.
6. MIC2/LINE 3 OUTPUT LEVEL CONTROL: Adjust the volume of the MIC2/LINE3 channel.
7. LINE1 OUTPUT LEVEL CONTROL: Adjust the volume of the LINE1 channel.
8. LINE2 OUTPUT LEVEL CONTROL: Adjust the volume of the LINE2 channel.
9. MP3 OUTPUT LEVEL CONTROL: Adjust the volume of the MP3 channel.
10. ZONE VOLUME CONTROL: Adjust the volume for zone 1 - 6 separately.
11. ECHO CONTROL: Turn to adjust the microphone echo effect.
12. ECHO TIME CONTROL: Turn to adjust the repeat value of the echo effect. Repeats will be increased when rotating
clockwise, repeats will be reduced when rotating counter-clockwise.
13. BASS CONTROL: Adjust the low frequencies of the corresponding channel.
14. TREBLE CONTROL: Adjust the high frequencies of the corresponding channel.
15. MASTER VOLUME CONTROL: Turn to adjust the master volume level.
16. STANDBY: Press to put the device in/out of standby.
3