GBS Jolly line CWM-1737 Instrucciones De Montaje página 9

• Check to have a minimum of 35 mm of effective thickness of cement to be able to place the
anchors (stops). Do not drill mortar joints! Make sure that the installation is carried out on a solid
part of the wall, in general at 2.54 mm minimum from the block side. It is preferable to use an
electric drill at slow speed rather than a pneumatic drill for the drilling in order to avoid the break-
age of the back of the hole when an empty space or cavity is entered.
• The installer must ensure that the support surfaces can sustain the total weight of the equipment,
the bracket, and the components with the needed safety.
• Use the wall plate as a template to mark the four points to be drilled on the wall. Two holes in the
upper slots and two in the lower row, as illustrated in Figure 1.1.
• Create the holes with a 10 mm bit for at least 60 mm of depth. Insert a dowel (W-B) in each of
the holes. Situate the plate on the wall using the four screws (W-A) and the four M6 washers (W-
C) as illustrated in Figure 1.1.
PLASTIC COVER ASSEMBLY
• Install the four plastic covers (D) on the wall plate as
illustrated in Figure 2.1.
MOUNTING ON BRICKS OR CEMENT:
9