BaByliss ST92E Manual De Instrucciones página 5

using time.
Temperature
130°C green
LED
155°C yellow
LED
155°C yellow
LED
180°C orange
LED
180°C orange
LED
205°C red LED
230°C red LED
• Take a section about 2 to 3 cm wide
and place it between the two heating
plates, near the roots of the hair.
• Press the straightener handles to-
gether, hold to keep the section
between the plates and glide slowly
from the roots to the tips.
• Note! When you are straightening,
you might hear some sizzling and see
some steam. Do not be concerned, this
could be because of evaporation of the
sebum, some residual hair products
(leave-in hair care, hairspray, etc.) or
excess water that is evaporating from
your hair.
• Take up a new section of hair and
continue until your hair is all straight.
• Repeat again if necessary, then re-
lease the straightener.
• Give your hair the final touch. Set your
straightened hair with a light misting
of hairspray or a little mousse, but
certainly do not brush your hair.
To shape your hair
• Work with dry hair. Take up a section
of hair, place it between the plates
Hair type
Fine, bleached
and/or dama-
ged hair
Normal, colou-
red and/or wavy
hair
Thick and/or
very curly hair
and then close the plates. Hold the
unit closed for about 15 seconds. Re-
lease, and then take up the next part
of the section using the last wave as
a guide. Always work from the roots
to the tips.
• For a more marked effect, first mist
the section with hairspray and hold
the unit closed for a little longer.
• Trick: for best results, work on
straight hair or hair that has first
been straightened.
• Give your hair the final touch. Set
your crimped hair with a light mis-
ting of hairspray or a little mousse,
but certainly do not brush your hair.
• After use, press the ON/OFF button
and unplug the unit.
• Allow the hot unit to cool on the
heat-resistant mat provided.
Automatic shut off
If the straightener/crimper remains
on for over 1hr 15min, it turns off
automatically.
CLEANING AND MAINTENANCE OF
YOUR STRAIGHTENER/CRIMPER
• Unplug the unit and allow it to cool
completely.
• Clean the plates using a soft, damp
cloth, without detergent, to preserve
the optimal quality of the plates. Do
not scratch the plates.
• Store the straightener/crimper with
the plates pressed together to pro-
tect them.
5