Idiomas disponibles
Idiomas disponibles
Note:
● When using the product for foot massage, it is necessary to adjust the intensity
with the "Intensity" button on the left side of the remote control. The intensity of foot
massage will have no change with the intensity adjustment button on the right side
of the remote control.
● The electrodes will begin to rock when there is enough stimulation on your feet. If
they don't rock, it needs to increase the level of stimulation.
3) Press "
" to switch among 9 treatment modes. Mode 1 provides massage in
automatic cycle and combination, while Modes 2-9 provide circular massage, that
is, automatically switching to the next mode every one minute; Modes 2-9 provide
single massage.
4) After power-on, you may short press "
within the range of 15-60 minutes; each press could switch to a different time
interval. It defaults to 15 minutes after startup.
5) Red light irradiation
The red light irradiation will be enabled automatically after the pulse intensity
increases to Level 1 and above after powering on the product, with your feet in full
contact with the electrodes. To disable the red light irradiation, please long press
"Mode" (this isn't applicable for models without the red light irradiation).
4.2.3 Application of electrodes to body parts
1) Connect one end of the 2-core connecting cable to the electrode interface
(marked with
electrodes.
2) Remove the protective film on electrodes and firmly apply them to your body
parts with a pain. Then, follow the instructions on them to operate the remote
control.
Note: be sure to adjust the massage intensity with the adjustment button on the
right side of the remote control, otherwise the intensity will have no change.
Please refer to the following figures for application of the electrodes:
Neck
Shoulder
) on one side of the main unit and the other end to the adhesive
Back
" to select the massage time interval
Hand
Calf
Hip
Joint
