Idiomas disponibles
Idiomas disponibles
IV. How to Operate It
4.1 Preparations before use
1) Mount 3 pieces of AA batteries for the main unit and 2 pieces of AAA batteries
for the remote control. Please pay attention to the positive and negative poles of
batteries. After completion of mounting, close the battery cover.
2) Clean your feet and the foot electrodes with a damp towel, and then place your
feet on the electrodes; then, position your feet to make them in full contact with the
two electrodes, then fully relax your body and begin to operate the remote control.
It is recommended to place a flannel on the electrodes in winter to keep your feet
warm during use of the product.
4.2 How to operate the remote control
4.2.1 Description on functions of remote control buttons
: Power on or off, and time adjustment
①
: Selection of an electric pulse mode
②
③ + : Increase the intensity of electric pulse
④ - : Decrease the intensity of electric pulse
4.2.2 Operate the remote control
1) First, press "Power" on the main unit with the indicator flashing to wait for the
display of signals; then, press "
the main unit beeps with the indicator always on, and the remote control displays as
below and enters the default settings:
• Timed for 15 minutes;
• Mode 1
• Intensity 0
Then, you may operate the remote control to adjust to the treatment mode and
intensity you desire; in operating the remote control, please aim its infrared emitter
at the infrared receiving port on the main unit. The product will beep once after
successfully receiving the infrared signal.
To power off the product, please press "
Note: the main unit in standby state will shut down automatically if it fails to receive
the power-on signal from the remote control within 3 minutes. To reuse the main
unit, you need to press "Power" on it to enter the standby state.
2) To adjust the intensity, please press "+" to increase a level while "-" to decrease
a level. 20 levels in total for adjustment. It defaults to Level "0" after startup.
" on the remote control to start the product; next,
" on the remote control or main unit.
