Parts; Assembly - PRETUL ESMA-4-1/2P2 Manual De Instrucciones

Spindle
lock
Abrasive Disc
4 / "
1
2
included
Outer
flange
Inner
flange
Auxiliary handle
assembling orifice
Protective guard assembly
• Disconnect the grinder and set it facing up.
• Set the protective guard in the grinder cutter head as shown. Then set the
pressure washer (A) onto the shaft.
• Tighten the four washer screws (B) to secure the guard.
• If using wire brushes instead of abrasive discs remove the guard reversing the
previous steps.
Disc assembly
1 Fix the inner flange in the axis.
2 Set the disc in the inner flange.
3 Set the outer flange in the axis.
• Press the axis lock in the grinder head.
4 Using the lock nut wrench, screw the outer flange until is fixed.
DANGER The axis lock can only be used
to replace discs. Never to stop the disc while it rotates.
The threaded mounting of the accessories must match the spindle
thread. Accessories that do not match the installation fixtures on the
tool will cause unbalance, excessive vibration and or may cause loss
of control.
Wire brushes assembly
• Flanges are not needed to fix this type of accessory. Just
screw the brush (not included) directly into the grinder shaft.

Parts

Protective
guard
Auxiliary
handle
Switch

Assembly

Handle
Power cord
Disc
Protective Ventilation
guard slots
3
2
Inner
flange
5/8-11-UNC-1A
B
Angle grinder
head
Lock nut
wrench (included)
protector
Spindle
lock
Protective
Power cord
Lock nut
wrench
flange
Disc
A
ENGLISH
guard
4
Outer
1
7