Parts; Assembly - PRETUL ESMA-4-1/2P2 Manual De Instrucciones

Spindle
lock
Abrasive Disc
4 / "
1
2
included
Outer
flange
Inner
flange
Auxiliary handle
assembling orifice
Protective guard assembly
• Disconnect the grinder and set it facing up.
• Set the protective guard in the grinder cutter head as shown. Then set the
pressure washer (A) onto the shaft.
• Tighten the four washer screws (B) to secure the guard.
• If using wire brushes instead of abrasive discs remove the guard reversing the
previous steps.
Disc assembly
• Fix the inner flange in the axis.
• Set the disc in the inner flange.
• Set the outer flange in the axis.
• Press the axis lock in the grinder cutter head.
• Using the lock nut wrench, screw the outer flange until is fixed.
DANGER The axis lock can only be used
to replace discs. Never to stop the disc while it rotates.
Wire brushes assembly
• Flanges are not needed to fix this type of accessory. Just
screw the brush (not included) directly into the grinder shaft.
6
ENGLISH
Protective
guard
Handle
Auxiliary
handle
Disc
Switch
Protective
guard

Assembly

5/8-11-UNC-1A

Parts

Ventilation
slots
Lock nut
wrench
3
2
Disc
Inner
flange
B
Angle grinder
cutter head
Lock nut
wrench (included)
Spindle
lock
Protective
guard
Power
cord
4
Outer
flange
1
A