Casselin CFRP1400 Manual De Instrucciones página 16

The device can cause injury if not properly installed. Before proceeding with its installation, compare the
EN
data of the local electrical network with the indications which appear on the nameplate of the appliance.
Connect the device only if there is conformity. Respect the safety rules.
Before connecting the device, make sure that the nominal voltage and frequency listed on the nameplate
comply with the values of the local electrical network: the maximum voltage difference must be plus or minus
10%.
The device must be earthed.
Place the device so that the socket is easily accessible in order to unplug the device if necessary.
USE
Connect the oven to the power cable.
On ignition and during the first few minutes, the thermal insulators used and the grease residues cause the
formation of smoke and give off an unpleasant smell. When lighting for the first time, it is advisable to ventilate
the room well and operate the oven empty, at maximum power, for 20-30 minutes.
To turn on the appliance, turn the timer knob (A) clockwise and set the desired time between 0 and 15
minutes. The orange indicator lamp (B) lights up to indicate that the device is powered on.
To use the oven in continuous mode, set the timer to the "manual" position by turning the knob counter-
clockwise until the mark is in the ON position.
To adjust the oven temperature, turn the thermostat knob (D) clockwise and set the desired temperature
between 50°C and 400°C. The green light (C) goes off when the temperature is reached. To turn off the
resistances before the programmed time, gently turn the timer knob counter-clockwise and return the marker
to the 0 position.
Caution: do not force this operation, there is a risk of irreparably damaging the timer.
Open and close the oven door using the handles.
Do not put your hands into the oven when it is on or still hot.
Use gloves and utensils suitable for this type of cooking.
REMARK
The appliance is equipped with a safety system in case of overheating. In the event of tripping, unplug the
appliance and allow it to cool. If this protection system activates regularly, it is essential to contact your
retailer.
After automatic shutdown, the device can only be put into operation by pressing the Reset button on the back
of the device. To do this, wait for the temperature to drop, press the Reset button.