Noise And Vibration - Flex DGE 25 18.0-EC Instrucciones De Funcionamiento

■ Support panels or any oversized
workpiece to minimize the risk of wheel
pinching and kickback. Large workpieces
tend to sag under their own weight.
Supports must be placed under the
workpiece near the line of cut and near the
edge of the workpiece on both sides of
the wheel.
■ Use extra caution when making a "pocket
cut" into existing walls or other blind
areas. The protruding wheel may cut gas
or water pipes, electrical wiring or objects
that can cause kickback.
Additional safety instructions for
wire brushing operations
Safety warnings specific for wire
brushing operations:
■ Be aware that wire bristles are thrown
by the brush even during ordinary
operation. Do not overstress the wires
by applying excessive load to the brush.
The wire bristles can easily penetrate light
clothing and/or skin.
■ This time no one is to stand in front or in
line with the brush. Loose bristles or wires
will be discharged during the run-in time.
■ Direct the discharge of the spinning wire
brush away from you. Small particles and
tiny wire fragments may be discharged
at high velocity during the use of these
brushes and may become imbedded in
your skin.

Noise and vibration

The noise and vibration values have been
determined in accordance with EN 60745.
The A evaluated noise level of the power tool
is typically:
– Sound pressure level L
– Sound power level L
– Uncertainty:
Total vibration value:
– Emission value a
– Uncertainty:
CAU TION!
The indicated measurements refer to new
power tools. Daily use causes the noise and
vibration values to change.
18
: 75 dB(A);
pA
: 86 dB(A);
WA
K = 3dB.
: 8.82m/s 2 (Φ25mm)
h
24.34m/s 2 (Φ50mm)
K = 1.5 m/s
NOTE
The vibration emission level given in this
information sheet has been measured in
accordance with a measurement method
standardised in EN 60745 and may be used
to compare one tool with another.
It may be used for a preliminary assessment
of exposure. The specified vibration emission
level represents the main applications of the
tool.
However, if the tool is used for different
applications, with different cutting accessories
or poorly maintained, the vibration emission
level may differ.
This may significantly increase the exposure
level over the total working period.
To make an accurate estimation of the
vibration exposure level, it is also necessary
to take into account the times when the tool
is switched off or running but not actually in
use.
This may significantly decrease the exposure
level over the total working period.
Identify additional safety measures to
protect the operator from the effects of
vibration such as: maintain the tool and the
cutting accessories, keep the hands warm,
organisation of work patterns.
severe injuries.
CAU TION!
Wear ear defenders at a sound pressure
above 85 dB(A).
2
DGE 25 18.0-EC
extremely