Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Calculation of body mass index
The MC-500 has a body mass index calculator.
The body mass index should be used as a guide only and should not be considered medical data.
1.
Turn on the equipment.
2.
Press repeatedly PROG until "F A t" appears on the screen.
Below, you will find input data on the left and the data value on
the right. The example image shows an age value of "52".
3.
Press MODE button to select the BMI data you wish to set.
Each press of the button jumps between the input data.
For each type of data, adjust the use value.
moving on to the next type of input data:
•
"F1" - Gender. The possible values are "01" for men, "02" for women.
•
"F2" - Age. Possible values are "10" to "99".
•
"F3" - Height in centimetres. Possible values are "100" to "240".
•
"F4" - Weight in kilograms. Possible values are "20" to "160".
•
"F5" - Physical detection. Place the palms of your hands on the pulse sensors and
hold them there until the BMI value is displayed.
4. When you are done, press STOP.
Platform inclination
The treadmill features a 15-position platform incline. This means that the platform end of the belt can
be raised/lowered up to a gradient of 15%. The higher the gradient, the more intense the workout.
Adjust the inclination of the strap platform using the ▲ / ▼.
MAINTENANCE
General
•
Make sure that you have switched off the device and disconnected the power plug before
maintenance.
•
Do not use abrasives or solvents to clean the tape, as this may damage the finish and
functionality.
•
Take care that excessive moisture does not enter the display panel as this may damage it.
•
Keep the equipment, especially the display console, out of direct sunlight.
•
To clean around the plug and control panel use a soft dry cloth, never use a wet cloth.
•
Do not use the treadmill in a wet or dusty environment as this may cause leakage or mechanical
failure.
•
Use this product on a flat surface.
+
−
/
before
Daily maintenance
Clean regularly to remove dust and sweat to protect the components. You should clean both sides
of the exposed part of the belt to avoid residue. Use a damp cloth with soap to clean the ribbon. Do
not use a cleaner. Wipe the sweat off the handrail and the strap after use.
Lubricant use
The platform and treadmill have been lubricated at the factory with an anti-static lubricant, but we can
re-lubricate it. Suggestion:
-
Use of - 3 hours per week-----lubricate every 6 months.
-
Use 4-7 hours per week-----lubricate every 3 months.
-
Use of + 8 hours per week-----lubricate once a month.
ATTENTION! Do not lubricate more than necessary. Remember that regular and reasonable lubrication
will increase the life of your treadmill.
Belt deflection adjustment
To improve the use of the belt, you can adjust it if you notice a deviation of the direction after
continuous use. To do this, adjust the bolts at the front of the base with the Allen key provided as
shown in the picture below.
WARNING! The belt should not be too tight as this can cause noise and possible damage to the engine.
23
EN - MC-500
In case of left-hand deviation, tighten the left-hand
screw clockwise or the right-hand screw anticlockwise.
In case of right-hand deviation, tighten the right-
hand screw clockwise or the left-hand screw
counterclockwise.
Tabla de contenido
