Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Attaching and Adjusting the
Shoulder Strap (Fig. M)
Optional Accessory, Sold Separately.
WARNING: The shoulder strap should only be slung
over one shoulder and not across the body. See Fig M.
A shoulder strap is recommended for any tool with a total
weight exceeding 13lbs. (6 kg). (Total weight includes
the tool, attachment, and battery.) A shoulder strap is
available at an additional cost from PORTER-CABLE at
www.portercable.com or call 1-888-848-5175, part
number N769443. Attach the strap to the tool as shown in
Fig. M and adjust for proper balance and support
WARNING: The strap should only be slung over one
shoulder and not across the body. See Fig M.
1. Snap the shoulder strap latch
strap mount
19
located on the unit, just in front of the
ON/OFF trigger as shown in Fig. M.
2. Adjust the strap so it fits over your shoulder and
provides proper balance and support.
Repairs
The charger and batteries are not serviceable. There are no
serviceable parts inside the charger or battery pack.
WARNING: To assure product SAFETY and RELIABILITY,
repairs, maintenance and adjustment (including brush
inspection and replacement, when applicable) should
be performed by a PORTER‑CABLE factory service center
or a PORTER‑CABLE authorized service center. Always
use identical replacement parts.
Register Online
Thank you for your purchase. Register your product now for:
• WARRAnTY sERViCE: Registering your product will
help you obtain more efficient warranty service in case
there is a problem with your product.
• COnFiRMATiOn OF OWnERshiP: In case of an
insurance loss, such as fire, flood or theft, your registration
of ownership will serve as your proof of purchase.
• FOR YOUR sAFETY: Registering your product will allow
us to contact you in the unlikely event a safety notification
is required under the Federal Consumer Safety Act.
• Register online at www.portercable.com
Troubleshooting
Problem
Unable to pull back rod
Unable to push rod forward
No grease when trigger is pulled
Grease appears in relief valve
Motor does not run when trigger is pulled
Grease leaks out of the back of the grease tube
33
onto the shoulder
Possible Cause
Vacuum build up
Pressure build up
Rod is still connected to plunger
Grease tube is empty
Air pockets in the grease tube
Zerk fitting is blocked
Battery
Rubber seal is flipped the wrong direction
Three Year Limited Warranty
PORTER-CABLE will repair or replace, without charge, any
defects due to faulty materials or workmanship for three
years from the date of purchase (two years for batteries).
This warranty does not cover part failure due to normal wear
or tool abuse. For further detail of warranty coverage and
warranty repair information, visit www.portercable.com
or call 1‑888‑848‑5175. This warranty does not apply to
accessories or damage caused where repairs have been
made or attempted by others. THIS LIMITED WARRANTY
IS GIVEN IN LIEU OF ALL OTHERS, INCLUDING THE IMPLIED
WARRANTY OF MERCHANTABILITY AND FITNESS FOR A
PARTICULAR PURPOSE, AND EXCLUDES ALL INCIDENTAL
OR CONSEQUENTIAL DAMAGES. Some states do not allow
limitations on how long an implied warranty lasts or the
exclusion or limitation of incidental or consequential
damages, so these limitations may not apply to you. This
warranty gives you specific legal rights and you may have
other rights which vary in certain states or provinces.
In addition to the warranty PORTER-CABLE tools are covered
by our:
1 YEAR FREE sERViCE
PORTER-CABLE will maintain the tool and replace worn parts
caused by normal use, for free, any time during the first year
after purchase.
90 DAY MOnEY BACK GUARAnTEE
If you are not completely satisfied with the performance of
your PORTER-CABLE Power Tool or Nailer for any reason, you
can return it within 90 days from the date of purchase with a
receipt for a full refund – no questions asked.
lATin AMERiCA: This warranty does not apply to products sold
in Latin America. For products sold in Latin America, see country
specific warranty information contained in the packaging, call
the local company or see website for warranty information.
FREE WARninG lABEl REPlACEMEnT: If your warning
labels become illegible or are missing, call 1‑888‑848‑5175
for a free replacement.
PORTER CABLE
4825 Highway 45 North, Jackson, Tennessee 38305
(888) 848‑5175 • www.portercable.com
Possible solution
Unscrew the purge valve to release vacuum.
Unscrew the purge valve to release pressure.
Rotate grease tube handle 90 degrees to disengage it.
Add grease.
Refer to Purging Air Pockets.
Disconnect coupler from fitting, clean zerk fitting and
grease path.
Make sure the battery is fully charged.
Refer to Preparing the Grease Gun for Suction
and Filler Pump Filling.
EnGlish
13
Tabla de contenido
