After Use - Würth 0891 385 008 Traducción Del Manual De Instrucciones De Servicio Original

Spraying pressure
1.5 bar
2.0 bar
3.0 bar
▸
If the pressure in the spra appliance falls b
0.5 bar or more belo the optimum value, pump
the pressure up again.
Note
If air containing li uid comes out of the
nozzle, the container is empt .
Fault
The device does not build up
an pressure.
Li uid escapes out of the
pump.
Piston manometer indicates
no container pressure, safet
valve blo s o too earl .
Nozzle does not spra , even
though pressure is available.
Shut-o valve does not close.
Li uid escapes ithout activa-
tion of the lever.
16
pra rate ith at
jet nozzle (initial
e uipment)
0.56 l/min
0.65 l/min
0.80 l/min
Cause
Pump not scre ed in tightl .
O-ring [13] on the pump defec-
tive. (Fig. 1 )
Sleeve [14] defective. (Fig. 1 )
Valve disc [15] dirt or defec-
tive. (Fig. 1 )
Piston manometer [16] defec-
tive. (Fig. 1 )
Filter [1 ] (Fig. 1 ) and/or noz-
zle [17] (Fig. 1 ) clogged.
O-Rings [23] of the pressure
pin [24] not greased/lubricat-
ed. (Fig. 21).
Piston pin [24] or O-rings [23]
defective. (Fig. 21).
Note
Observe the notes in the "safet
Never allo li uid to get into the device.
▸
Pull the red knob of the piston manometer [8] up
until the container is depressurised. (Fig. )
▸
Lock the plunger ith handle [10]. (Fig. )
▸
Screw the pump [2] out of the container. (Fig. )
▸
Dilute the residual uantit t ice se uentiall ,
each time ith 1/2 litre of ater, and spra this
li uid onto the treated surface.
▸
Wipe o the device using a damp cloth.
▸
To dr and store, store the container [1] and
pump [2] separatel in a dr , frost-free environ-
ment, shielded from sunlight. (Fig. 12)
▸
fter use, clean the protective e uip-
ment.
Faults

After use

Remed
Scre the pump in tightl .
Replace O-ring.
Replace sleeve.
Clean or replace valve disc.
Replace the piston manometer.
Clean filter or/and nozzle.
Grease the O-ring of the pres-
sure-pin (disassemble and/or
assemble shut-o valve)
Replace pressure pin or O-ring.
section.