Tabla de contenido
Idiomas disponibles
Idiomas disponibles
MINIMUM MANTEL CLEARANCES
WARNING
WHEN USING PAINT OR LACQUER TO FINISH THE MANTEL, THE PAINT OR LACQUER MUST BE
HEAT RESISTANT TO PREVENT DISCOLOURATION.
39.37" (1000mm)
Wall Mounted Installation
Due to the many different materials used on different walls, it is highly recommended that you consult your local
builder before you install this appliance on the wall.
A.Select a location that is not prone to moisture and is located at least 36" (914mm) away from combustible
materials such as curtain drapes, furniture, bedding, paper, etc.
B.Have two people hold the appliance against the wall to determine the final location.
C.Place unit face down on a soft, non abrasive surface. Remove the bracket from the back of the unit by removing
the screws, refer to Figure 1.
D.Mark out location, then mount the bracket(s) onto the wall using the supplied screws. This bracket MUST have
the slots facing upward and be level.
NOTE: It is strongly recommended that the mounting bracket (E) be Screwed into the wall studs Where
possible. If the wall Studs cannot be used, ensure
That the supplied plastic anchors are used to affix the bracket to the wall and the bracket is adequately
secured.
E. With the wall mounting bracket installed have two people lift the appliance up and insert the hooks on the back
12
Tabla de contenido
