Eco-Mode; Ac Operation; Dc Operation; Usb-Port - Zipper ZI-STE2000IV Instrucciones De Servicio

13.6.3

ECO-mode

13.7

AC Operation

1. Verify that the green indicator light (running) is on after starting the engine. This indicates that
the machine is working properly.
2. Check that the ON-OFF switch of the electrical devices to be used is set to "OFF".
3. Connect the device to the AC-socket.
4. Start the device.
NOTE:
When connecting several devices, connect them in decreasing order of their kW
consumption!
13.8

DC Operation

12V charging function for batteries: Before operation, observe the instructions and notes of the battery
manufacturer. If the indicated charging currents/voltages of the machine are not permissible or not known
for your battery, charge the battery via a battery charger to avoid damage.
1. During the direct current operation, switch off the ECO-mode. To do this, set the switch of the
ECO-mode to the "0" position.
2. First connected the charging cable to the DC-connection of the machine.
3. Then link the charging cable to the connectors of the battery.
4. Start the machine.
NOTE:
Do not charge built-in batteries.
•
Do not change the polarity of the charging cable, otherwise serious results such as damage of
•
the machine and the battery will be caused.
When disconnecting the charging cable, start with the battery first.
•
A battery contains acid (electrolyte). Any contact with the skin or eyes will cause severe burns.
•
Use a mask, eye protection and protective clothing.
13.9

USB-Port

The USB-port on the control panel can be used for charging electrical devices (5Vdc, max. 2A) which are
compatible with the USB standard.
ZIPPER MASCHINEN GmbH www.zipper-maschinen.at
The ECO-mode is recommended to reduce fuel consumption
during operation.
With the activated ECO-mode, the machine automatically
reduces the engine speed depending on the load. This results in
less fuel consumption.
NOTE:
In case of low power output, the ECO-mode can be
activated (switch (1) in position "I").
In case of high power output and DC operation, the ECO-
mode must always be deactivated (switch (1) in position "0").
NOTE: AC and DC sockets can be used simultaneously.
An overload of the DC circuit can cause the DC-circuit breaker
12V (1) to be activated (the pressure spring of the switch pops
up).
If this happens, wait a few minutes. In order to resume
operation, press the DC-circuit breaker 12V (1).
OPERATION
37
ZI-STE2000IV