Tabla de contenido
Chassis variant
Bus ignore mode
The digital values for the IF variants in BeoVision 5 are the following:
B/G
=
1
B/G/L/L'
=
3
B/G/D/K
=
9
I
=
16
B/G/L/L'/I
=
19
M/I/D/K
=
28
B/G/M/I/D/K =
29
Press GO to save the digital value.
AFC On/Off is used in connection with adjustments but it may also be useful in
other situations. Press
m
p
Press
/
to switch between On/Off.
AFC Off cannot be stored. AFC is always On after stand-by.
- Chassis variant setup. In BeoVision 5 the line "Internal VCR" must always be set to No.
Remember to check the line if the EEPROM 6IC6 has been replaced.
If an error occurs in the I²C bus system which makes the TV go into stand-by every
time it is attempted to be switched on, it is possible to switch on the TV in such a
way that the error is ignored:
- The TV must be on stand-by for at least 5 seconds.
- Short-circuit the service socket, P84 on AV Switch PCB14, coordinate 5L, for a
minimum of 0.5 second. See
- Remove the jumper.
- Press TV. The TV will now start up in the bus ignore mode if that is possible.
l
n
/
to move the cursor.
3.
Service Mode, English
5.9
Tabla de contenido
