Contents; Ce Labelling; Safety Instructions - ALFRA 03200SET.NG Manual De Instrucciones

eN
Dear customer,
We thank you for choosing our Alfra product. Read these operating instructions carefully before using your
new unit for the first time and retain them together with the supplied Product Control Card so they can be
consulted when required.

1. ce laBellIng

ALFRA confirms the conformity of the "stationary busbar bending and hole-punching unit" with the
machine directive 2006/42/EC and with the EMC directive 2014/30/EU. An appropriate declaration of
conformity has been issued. It can be found at the end of this document or accompanies the unit as
separate document.

2. safety InstructIons

2.1 symbols in these operating instructions
The following symbols are used in this documentation:
warning!
!
a hazardous situation which may lead to death or serious injury if the instructions
are not followed.
caution!
!
hazardous situation which may lead to (minor) injuries if the instructions are not followed.
note:
Important notices and indication of situations which may result in material damage.
This symbol indicates an "action point" and shows that you should perform an operation or work step.
2.2 symbols on the unit
The following symbols are attached to the unit.
warning of laser radiation.
risk of small particles being ejected.
risk of being crushed or cut by swinging workpieces.
risk of being crushed or cut by moving unit components.
observe the operating instructions.
wear safety goggles.
Maximum dimensions of workpieces.
17