Eldom star HM1300 Manual De Instrucciones página 12

Ocultar thumbs Ver también para star HM1300:
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 22
OPERATING INSTRUCTION
EN
RADIANT-CONVECTOR HEATER HM1300C
• GENERAL DESCRIPTION
1. Indicator light
2. ON/OFF switch
3. Thermostat
4. Cord storage space
5. Feet
6. Ventilation openings
• TECHNICAL DATA
− power: 2000 W
− supply voltage: 220-240V ~ 50-60Hz
• INTENDED USE
The HM1300 heater is designed for heating
living and office spaces.
• INSTALLATION
− Carefully place the device with its feet upwards
(soft surface is best used to avoid damaging of the protection coat).
− Install the feet - pic. 1.
− Turn the heater back to the proper vertical position.
Do not cover outlets when the appliance is in operation.
• OPERATION
− After unpacking the appliance, make sure it has not been damaged during transport. In case of any doubts,
do not use the appliance until consulting a service center. Put the appliance onto a flat, stable and high
temperature resistant ground.
The appliance works in a vertical position only. It is equipped with protection system which cuts off
power supply in case of overturning.
− Turn the switch (2) to position "0" (appliance turned off).
− Turn the switch (3) to position "OFF".
− Connect the appliance to a power source with parameters
in accordance with the Instructions for Use.
− choose operation mode by turning the knob (2):
„I" -
1000W
„II"
- 2000W
− The appliance starts working after choosing the
temperature by turning the thermostat hand wheel (3).
− The appliance work is signaled by control lamps (1).
When used for the first time, the heating elements and
insulation can emit characteristic smell.
It is a normal phenomenon.
The device has a thermal safeguard cutting off the power supply when it is overheated. In this case, set
the thermostat knob (3) in the "OFF" position, disconnect the device from the power supply and
eliminate the cause of overheating. Leave the device to cool down before switching the device on again.
• CLEANING AND MAINTENANCE
− Disconnect the device from the power supply before cleaning.
− The device must not be immersed in water.
− Do not use cleaning agents and products that are strong or destructive to the surface.
Wipe the enclosure with damp cloth.
12
INSTRUCTION MANUAL
RADIANT-CONVECTOR HEATER H H M M 1 1 3 3 0 0 0 0
pic. 1
Tabla de contenido
loading

Tabla de contenido