Battery Charging; Power Supply - Pulseroll VIBRATING SINGLE BALL Manual

Never put the product in water to clean it and always make sure that the water or any other fluid
cannot does not get into the product.
Do not use the product if it has a damaged cable or plug; if it is not working properly then contact
Pulseroll to discuss repair or replacement. The integrated batteries are not designed for exchange or
removal by the customer. If problems with the power supply should occur, contact Pulseroll. If signs
of water inside the product are present then the warranty may then be void.

BATTERY CHARGING

• Your Pulseroll operates on Lithium Ion batteries (7.4V, 2200mAh)
• The product will not charge unless it has been turned off.
• Charge the product before using it for the first time until the battery indicator shows it's fully
charged.
• To charge the batteries fully, the charging time will take approx. 3 Hours. When fully charged you
can use for up to 6 Hours (level 1) or 2 Hours (level 4).
• If the vibration intensity ceases significantly then turn off and fully recharge.
• The product may be recharged at any time regardless of the battery level.
• The product needs to be fully recharged at least once every 3 months.

POWER SUPPLY

• Use the product only with the voltage specified on the unit. Using a voltage higher than that
which is recommended may cause fire or electric shock.
• Only insert the power supply unit into a socket when the product has been switched off.
• Only use the power supply unit supplied for your Pulseroll.
• Charge the product before using it for the first time until the battery indicator shows it's fully
charged.
• Do not cut, kink, otherwise damage or modify the power supply cord.
• Keep the power supply unit, cable and product far away from heat, hot surfaces, moisture
and liquids.
• Do not touch the power supply unit when you are standing in water and always do take
hold of the plug with dry hands.
• Do not touch the product or power supply if it falls into water when plugged into charge. Pull out
the power plug and the power supply unit from the socket immediately.
EN