SentrySafe Master Lock Fire-Safe Manual Del Propietário página 7

Unlocking your safe using the electronic keypad
NOTE: • Factory installed batteries included.
• Delay mode will occur if three consecutive invalid entries have been tried. Red LED will
blink on and off to let you know the safe is in delay mode. This will cause the system to
shutdown for two minutes. DO NOT remove the batteries to restart the system it will only
increase the length of time for the system shutdown.
Locking your safe using the override key only (for select models)
Locking your safe using the electronic keypad
NOTE: • If your safe does not appear to be working properly, please check to make sure you are
using NEW CR123 lithium batteries before contacting customer Service.
Enter the 5 digit factory code found on the back of the
1
owner's manual.
The green light will stay illuminated to indicate the code is
2
correct. You will have 5 seconds to open your safe.
Pull handle outward to open the door.
3
Close the door to re-engage locking bolts.
1
Turn key to the 'locked' position.
2
Close the door to re-engage locking bolts.
1
Wait 5 seconds and try to open your safe without entering any
2
code or using the override key to ensure safe is locked.
7