sunjoe SPX160E-MAX Manual Del Operador página 9

Fig. 10
Operation
m
IMPORTANT!
This pressure washer is equipped with
a micro-switch sensitive to water flow. This Total Stop System
(TSS) senses water flow in the pump. When the trigger is
released, water stops flowing through the pump. The TSS then
automatically turns the motor off to protect the pump from
overheating, thus saving energy and prolonging pump life.
1. Turn the water supply tap on completely.
2. Make sure the safety lock is unengaged, then press
the trigger for a few seconds until water flow is steady.
This will allow air to escape and discharge any residual
pressure in the hose.
3. Press the ON/OFF switch to start the pressure washer.
Using the Nozzles
Each nozzle has a different spray pattern. Determine the best
nozzle according to the cleaning task to be performed. This
electric pressure washer is equipped with two (2) nozzles that
easily snap onto the Quick-Connect collar of the stainless steel
lance.
m
CAUTION! NEVER change nozzles without locking the
safety lock on the trigger handle.
m
WARNING!
High-pressure jets can be dangerous if
subject to misuse. The jet must not be directed at persons,
pets, live electrical equipment, or the appliance itself.
To connect a nozzle to the extension lance:
1. Turn off the pressure washer and shut off the water supply.
Pull the trigger to release the water pressure.
2. Engage the safety lock on the trigger to prevent
unintentional start (Fig. 11).
Fig. 11
3. Pull the collar and insert a desired nozzle. Release the
collar to lock the nozzle in place (Fig. 12).
Fig. 12
To disconnect a nozzle from the extension lance once the
cleaning job is complete:
4. Turn off the pressure washer and shut off the water supply.
Pull the trigger to release water pressure.
5. Engage the safety lock on the trigger to lock the trigger.
6. Remove the nozzle by placing your hand over the nozzle
while pulling back on the Quick-Connect collar.
m
WARNING!
Do not make changes to the nozzle while
the trigger is engaged. Doing so could result in damage to the
pressure washer or injury to the user.
9