Stihl FC-MM Manual De Instrucciones página 11

English / USA
Do not operate using the starting throttle
lock as you do not have control of the
engine speed. See section of your
MultiEngine instruction manual on the
proper use of the slide control.
If the cutting tool or deflector becomes
clogged or stuck, always turn off the
engine and make sure the cutting tool
has stopped before cleaning. Grass,
weeds, etc. should be cleaned off the
cutting tool at regular intervals.
!
Warning!
During cutting, check the tightness and
the condition of the cutting tool at regular
intervals. If the behavior of the cutting
tool changes, stop the engine
immediately, and check the cutting tool
for cracks and damage. Replace
cracked, bent, warped, damaged or dull
cutting tools immediately. Such cutting
tools may shatter at high speed and
cause serious or fatal injury.
10
!
Important!
Check the tightness and condition of the
cutting tool at regular intervals during
cutting. If the behaviour of the cutting
tool changes, stop the engine
immediately and examine the cutting
tool. Cracked, bent, warped or damaged
cutting tools must be replaced
immediately. Such tools may shatter at
high speeds and cause injuries.
Do not attach any blade to a unit without
proper installation of all required parts.
Never use unauthorized parts to secure
the blade. Failure to use the proper parts
may cause the blade to fly off and
seriously injure the operator or
bystanders.
Important adjustments
!
Warning!
To reduce the risk of personal injury from
loss of control or contact with the
running cutting tool, do not use a cutting
tool with incorrect idle adjustment. At
correct idle speed, the cutting tool
should not move. For directions on how
to adjust idle speed, see the appropriate
section of the MultiEngine instruction
manual.
If you cannot set the correct idle speed,
have your STIHL dealer check your
edger and make proper adjustments and
repairs.
FC-MM