Overload Message; Totalisation Of The Weight; Manual Or Automatic Totalization; Counting Pieces - Scale House HLD Serie Manual De Instrucciones

product is added only the weight of the product will be shown. The scale could be tared a second time if another type
of product was to be added to the first one. Again only the weight that is added after taring will be displayed.
When the container is removed a negative value will be shown.
To remove the tare, unload the scale and press again TARE.

6.4 OVERLOAD MESSAGE

Please do not add item that is over the maximum capacity. When reading "- - - - - -" and hear beeping sound, remove
the item on the platter to avoid damage to the load cell.

6.5 TOTALISATION OF THE WEIGHT

The scale can be set to accumulate manually the weight on the scale by pressing the PRINT/M+ key (see step "AU",
chapter 7.1).
The weight displayed will be stored in memory when the PRINT/M+ key is pressed and the weight is stable.
The display will show "ACC 1" while the weight will be printed, then the total in memory for 2 seconds before returning
to normal.
Remove the weight, allowing the scale to return to zero and put a second weight on. Press the PRINT/M+ key, the
display will show " ACC 2" and then the new total.
Continue until all weights have been added.
To view and print the totals in memory press PRINT/M+ key when current scale in zero status (Zero indicator on)
To clear the accumulated total weight, press the PCS key when show total values.
Scale automatically exit form the visualization of the total values after few seconds.
NOTE:
- The totalisation functions with a minimum weight of 20d.
- The maximum number of totalisations is 999 while the maximum total value which may be accumulated is
999999.
Once reached these limits, one should clear the total; by pressing PRINT/M+ the message "AdErr" will appear on
the display.
- The total values will be cleared when it's turned off.

6.5.1 MANUAL OR AUTOMATIC TOTALIZATION

The operation of accumulation, normally done manually with key PRINT/M+, can be done automatically when the
weight is stable. In regards to the choice of the totalisation execution mode, see step "AU", section 7.1.

6.6 COUNTING PIECES

Through the reference function it's possible to use the scale as a piece counter.
COUNTING PROCEDURE
The operations to be carried out are the following:
1)
Place the empty container on the scale and press TARE to tare it.
2) Check that the zero is on the display and put the quantity of pieces chosen for the SAMPLE on the scale and
press PCS key
.
3) The display suggests a REFERENCE QUANTITY. The possible options are: 10, 20, 50, 100, and 200.
4) Press TARE the number of times needed to reach the desired sample size.
8