Accessories - Festool OF 1400 EQ-F Instrucciones De Uso Originales

English
Customer service and repairs must
only be carried out by the manufac­
turer or service workshops. Find the
nearest address at:
www.festoolusa.com/service
Always use original Festool spare
EKAT
4
parts. Order no. at:
www.festoolusa.com/service
5
3
2
1
The tool is equipped with special self-discon­
necting carbon brushes. If they wear out, the
power supply is disconnected automatically and
the tool stops.
Check all warnings on the electric power tool
for readability and completeness. Replace
missing or illegible warnings.
Observe the following instructions:
► Damaged safety devices and components
must be repaired or replaced in a recog­
nised specialist workshop, unless otherwise
indicated in the operating instructions.
► To ensure constant air circulation, always
keep the cooling air openings in the housing
clean and free of blockages.
To change the position of the clamp lever [11]
► Undo the screw .
► Remove the clamp lever and tighten the
hexagon screw.
► Put the clamp lever back into the required
position and secure it with a screw.
11
3
2
1

11 Accessories

Use only original Festool accessories and
Festool consumable material intended for this
machine. These components are designed spe­
cifically for this machine. Using accessories
and consumable material from other suppliers
will most likely affect the quality of your results
and limit warranty claims. Machine wear or
your own personal workload may increase de­
pending on the application. Protect yourself and
your machine, and preserve your warranty
claims by always using original Festool acces­
sories and Festool consumable material!
16
The order numbers of the accessories and tools
can be found in the Festool catalogue or on the
Internet under www.festoolusa.com.
11.1 SYSTAINER
Systainer
Many Festool products are shipped in a unique
system container, called "Systainer". This pro­
vides protection and storage for the tool and ac­
cessories. The Systainers are stackable and
can be interlocked together. They also can be
interlocked atop Festool CT dust extractors.
To open the Systainer
Turn the T-loc [SYS-b-1] to this posi­
tion.
To lock the Systainer
Turn the T-loc [SYS-b-1] to this posi­
tion.
To connect two Systainers
Place one Systainer on the top of the other
(Fig. [SYS-a]).
Turn the T-loc [SYS-b-1] to one of
this positions (Fig. [SYS-b]).
The Systainers are connected and locked.
A Systainer Classic Line can be connected
to a Systainer T-Loc or to a Systainer
from below via its four locking devices.
A Systainer T-Loc can be connected to a
Systainer 3 both from below and from
above.
3
SYS-a