Dust Extraction; Working With The Electric Power Tool - Festool OF 1400 EQ-F Instrucciones De Uso Originales

English
If the zero position is incorrect, this can be
corrected using the screw [1-2] on the in­
dicator [1-3].
8.6 Specifying the routing depth
The required routing depth can be specified us­
ing either quick depth adjustment or fine depth
adjustment.
Quick depth adjustment
► Pull the depth stop [1-7] upwards until the
indicator [1-3] points to the required rout­
ing depth.
► Clamp the depth stop in this position using
the clamp lever [1-6].
Fine depth adjustment
► Clamp the depth stop using the clamp lev­
er [1-6].
► Set the required routing depth by turning
the adjusting wheel [1-4].
Turning the adjusting wheel by a mark
changes the routing depth by 0.004"
(0.1 mm). A full rotation changes the rout­
ing depth by 1/16" (1 mm). The maximum
adjustment range for the adjusting wheel
is 5/16" (8 mm).
8.7 Clamping the routing depth
► Open the rotary knob [1-5] and push the
power tool down until the depth stop touch­
es the fixed stop.
► Clamp the power tool in this position by
closing the rotary knob [1-5].
8.8

Dust extraction

WARNING
Heath hazard posed by dust
► Always work with an extractor.
► Comply with national regulations.
► Install the dust extraction attachment on
the router table:
▻ Position the dust-extraction attachment
with the two tenons [3-1] in the recess­
es [3-2] on the router table.
▻ Position the dust-extraction attachment
on the router table and pull the lev­
er [3-5].
12
To enable the dust-extraction attachment
to be attached and removed when the
router is fitted, the cut-out [3-3] in the ex­
tractor connector can be opened by turn­
ing the segment [3-4].
To ensure optimal dust extraction, the cut-
out with the rotatable segment must be
closed while work is carried out.
A Festool dust extractor with an extractor hose
diameter of 1-7/16" (36 mm) or 1-1/16" (27 mm)
(1-7/16" (36 mm) recommended due to the re­
duced risk of clogging) can be connected to the
extractor connector [3-6].
3
3-1
3-2
CAUTION! If an anti-static suction hose is not
used, static charge may occur. The user may
receive an electric shock and the electronics of
the power tool may be damaged.
Chip deflector KSF-OF
The chip deflector KSF-OF (available as an ac­
cessory depending on the model) can improve
the efficiency of the dust extraction system
when edge routing.
The chip deflector is installed in the same way
as the copying ring, see figure [8].
A hacksaw can be used to cut along the grooves
of the guard and therefore make it smaller. The
chip deflector can then be used for inner radii
down to a minimum radius of 1-1/2" (40 mm).
9 Working with the electric
power tool
When working on the machine, observe
all of the safety warnings that are listed
at the start as well as the following rules:
3-6
3-5
3-4
3-3