Changing Tools - Festool OF 1400 EQ-F Instrucciones De Uso Originales

Due to the built-in restart protection, the power
tool cannot be switched on and off via an exter­
nal switch module.
8.2

Changing tools

CAUTION
Risk of injury from hot and sharp insertion
tool
► Do not use any blunt or faulty insertion
tools.
► Wear protective gloves when handling an
insertion tool.
To change tools, turn the power tool upside
down.
Inserting the tool
► Insert the routing tool into the open collet
as far as possible or at least up to the
mark on the router shank.
If the collet [3A-2] cannot be seen due to
the union nut [3A-3], the routing
tool [3A-1] must be inserted into the collet
to the extent that the mark
projects beyond the union nut.
► Press the switch [1-14] for the spindle stop
on the right-hand side.
► Tighten the nut [1-15] using an open ended
spanner (WAF 24).
The spindle stop only jams the motor spin­
dle in one direction of rotation. Therefore,
there is no need to use a spanner for tight­
ening and loosening nuts. Instead, a ratch­
et can be moved backwards and forwards.
Removing the tool
► Press the switch [1-14] for the spindle stop
on the left-hand side.
► Undo the nut [1-15] using an open ended
spanner (WAF 24) until you can feel resist­
ance. Overcome the resistance by continu­
ing to turn the open ended spanner.
► Remove the router.
3A
3A-1
3A-2
3A-3
8.3
Collets are available for the following shaft di­
ameters: 1/4" (6.35 mm); 5/16" (8.0 mm);
3/8" (9.53 mm); 1/2" (12.7 mm) (See Festool
catalogue or online at www.festool.com for the
order numbers)
no longer
► Completely unscrew the nut [1-15] and re­
move it together with the collet.
► Only insert a new collet into the spindle if a
nut is fitted and engaged.
► Gently screw in the nut. Do not tighten the
nut if no cutter is inserted.
8.4
The routing depth is set in three steps:
1. Set the zero point, see 8.5.
2. Specify the routing depth, see 8.6.
3. Clamp the routing depth, see 8.7.
8.5
► Release the clamp lever [1-6] so that the
depth stop [1-7] can move freely.
► Position the router with the router ta­
ble [1-9] on a level surface. Open the rotary
knob [1-5] and push the power tool down­
wards until the cutter sits on the surface.
► Clamp the power tool in this position by
closing the rotary knob [1-5].
► Press the depth stop [1-7] against one of
the three fixed stops of the rotatable step­
ped stop [1-8].
A screwdriver can be used to individually adjust
the height of each fixed stop.
► Push the indicator [1-3] downwards so that
it points to 0" (0 mm) on the scale.
Changing the collets
Setting the routing depth
Setting the zero point
English
11