Service And Customer Care - Kenwood AT340 Instrucciones

To use the small feed tube - first
put the larger pusher inside the
feed tube .
To use the larger feed tube -
use both pushers together
10 Put the food inside the feed
tube.
11 Switch the mixer onto speed
3 and at the same time push
down evenly with the pusher
– never put your fingers in the
feed tube.
At the completion of the
processing operation, raising
and lowering the pusher
several times may help to
reduce the amount of food
left on the cutting plate.
12 Switch off and unplug.
Hints
Always use fresh
ingredients
Don't cut food up too small.
Fill the width of the large
feed tube fairly full. This
prevents the food from
slipping sideways during
processing. Alternatively,
use the small feed tube.
When using a chipper
plate, place thin ingredients
horizontally.
When slicing or shredding,
food placed upright comes
out shorter than food
placed horizontally.
Cleaning
Always switch off and
unplug before removing the
attachment from the kitchen
machine.
Dismantle the attachment
fully before cleaning.
For easier cleaning always
wash the parts immediately
after use.
Handle the cutting plates with
care – they are extremely
sharp.
Never immerse the gearbox
assembly in water or allow it
to get wet.
All remaining parts can be
washed in hot soapy water,
then dried thoroughly. Take
care as the cutting plates
. are sharp. Alternatively wash
in the dishwasher (top rack
only).
Service and
customer care
UK only
If you need help with:
•
using your attachment
•
servicing or repairs (in or
out of guarantee)
call Kenwood Customer
Care on 023 9239 2333.
•
spares and attachments
call 0844 557 3653.
other countries
If you experience any
problems with the operation
of your attachment, before
requesting assistance visit
www.kenwoodworld.com.
Please note that your
product is covered by a
warranty, which complies
with all legal provisions
concerning any existing
warranty and consumer
rights in the country where
the product was purchased.
If your Kenwood product
malfunctions or you find
any defects, please send it
or bring it to an authorised
KENWOOD Service
Centre. To find up to date
details of your nearest
authorised KENWOOD
Service centre visit
www.kenwoodworld.com or
the website specific to your
Country.
Designed and engineered by
Kenwood in the UK.
Made in China.
4